Section: Linux Programmer's Manual (2)
Return to Main Contents
umount, umount2 - unmount filesystem
int umount(const char *target);
int umount2(const char *target, int flags);
remove the attachment of the (topmost) filesystem mounted on
Appropriate privilege (Linux: the
capability) is required to unmount filesystems.
Linux 2.1.116 added the
system call, which, like
unmounts a target, but allows additional
controlling the behavior of the operation:
- MNT_FORCE (since Linux 2.1.116)
Force unmount even if busy.
This can cause data loss.
(Only for NFS mounts.)
- MNT_DETACH (since Linux 2.4.11)
Perform a lazy unmount: make the mount point unavailable for
new accesses, and actually perform the unmount when the mount point
ceases to be busy.
- MNT_EXPIRE (since Linux 2.6.8)
Mark the mount point as expired.
If a mount point is not currently in use, then an initial call to
with this flag fails with the error
but marks the mount point as expired.
The mount point remains expired as long as it isn't accessed
by any process.
unmounts an expired mount point.
This flag cannot be specified with either
- UMOUNT_NOFOLLOW (since Linux 2.6.34)
if it is a symbolic link.
This flag allows security problems to be avoided in set-user-ID-root
programs that allow unprivileged users to unmount filesystems.
On success, zero is returned.
On error, -1 is returned, and
is set appropriately.
The error values given below result from filesystem type independent
Each filesystem type may have its own special errors and its
own special behavior.
See the Linux kernel source code for details.
A call to
successfully marked an unbusy filesystem as expired.
could not be unmounted because it is busy.
points outside the user address space.
is not a mount point.
was called with
- EINVAL (since Linux 2.6.34)
was called with an invalid flag value in
A pathname was longer than
A pathname was empty or had a nonexistent component.
The kernel could not allocate a free page to copy filenames or data into.
The caller does not have the required privileges.
are available in glibc since version 2.11.
These functions are Linux-specific and should not be used in
programs intended to be portable.
function was called as umount(device) and would return
when called with something other than a block device.
In Linux 0.98p4, a call umount(dir) was added, in order to
support anonymous devices.
In Linux 2.3.99-pre7, the call umount(device) was removed,
leaving only umount(dir) (since now devices can be mounted
in more than one place, so specifying the device does not suffice).
This page is part of release 3.74 of the Linux
A description of the project,
information about reporting bugs,
and the latest version of this page,
can be found at
- RETURN VALUE
- CONFORMING TO
- SEE ALSO
This document was created by
using the manual pages.
Time: 05:47:28 GMT, September 20, 2017